Description

Gyratory Compactors enable engineers to reproduce real world compaction conditions during road paving operations, allowing them to ascertain the compaction qualities of an asphalt mixture.

Light and portable GYROCOMP EmS is the ideal solution for Quality Control (QC) that can even be easily installed in mobile laboratories.

The new electromechanical actuator makes it a 100% stand-alone machine, as it only requires single-phase power supply and no external air compressor which reduces the amount of maintenance and makes it easier to install.

GYROCOMP EmS full
electromechanical centrifugal compressor;
complies with EN, ASTM and AASHTO;
Internal angle of inertia preset to
1.16° according to AASHTO T312 and ASTM D6925;
Complies with EN 12697-10 EN 12697-31
AASHTO T312/TP4 SHRP M-002 ASTM D6925;

• EmS Electromechanical servo actuation without pneumatic connection
  connection or hydraulic power supply;
• Integrated colour control panel with large 7″ 16:9 display
• Approved as a Superpave Gyratory compressor in the United States
• Load application by electromechanical actuator,
  adjustable from 80 to 900 kPa with a 150 mm diameter specimen
  and 160 to 1500 kPa for a 100 mm diameter specimen;
• Internal angle adjustable from 0.7 to 1.4°,
  Standard factory setting: 0.82°
  (EN12697-31 see accessories) or 1.16° (ASTM D6925 AASHTO
  T312 SHRP M-002). Vertical load measurement by load cell;
• Number of cycles adjustable from 1 to 9999
• Gyration rate from 5 to 60 cycles/min (30 cycles/min) according to standard;
• Height measurement with 0.1 mm accuracy;
• Sample compaction with three possible end modes: number of revolutions
  Maximum height and density
  Power: 1700 W;
  230V/50-60Hz/1~;
  Dimensions: (WxDxH): 469 x 615 x 1130 mm
  Dimensions: (including extruder table, WxDxH): 502 x 753 x 1940 mm
  Weight: approx. 100 kg, weight with extruder: approx. 150 kg
  
  Order number: BP402000
  
  Accessories
  
• Calibration of the angle for Galileo or Gyrocomp EmS 0.82° – Order no. BP402000-1
• Integrated working plate with motorised sample extruder – Order no. BP402000-2
• Stainless steel wear disc using mould Ø 150mm – Order no. BP402000-3
• PC software for the Gyrocomp EmS – Order no. BP402000-4
• Hardened cylinder mould, Ø 150mm, compl. w. top a. bottom plate – Order no. BP400000-5
• Intermediate piece Ø 150 mm x 50 mm for low samples – Order no. BP400000-5
• Paper discs with 150 mm diameter, 1000 pcs. – Order no. BP400000